Loading...
Loading...
EM2 · EM2 Dante · EM4 · CHG70N · CHG70N-C
Just select the device from the module config window and enter the control IP of your EM2/EM4 receiver or network charger and press 'Save'. To control multiple devices, just add the connection several times to your Companion instance. For receivers with firmware >= 4.0.0 : please enable the "Legacy Mode" in the Sennheiser WSM Software for the receiver, to be able to control the devices using the SCP v1 protocol. If this is not done, you can't control your devices via Companion at this point.
This module stores pretty much all information the connected devices provide - some of them are available as feedbacks - but not all of them! So make sure to explore the "Variables" tab in Companion, to get an overview about all available information (e.g. Mounted Capsule on SKM, Battery charging cycles, transmitter type, etc.)
In the module presets you will find a status display for every receiver channel of your device. It contains the following information:
Beside this information the following icons are used:
AF Peak
Warning - one or more warnings are currently present on the receiver channel
Encryption - Disabled
Encryption - Enabled
Encryption - Error (for example because Encryption was disabled and enabled again without syncing the transmitters again)
Muted - Either the transmitter or receiver is muted
RSQI - Good signal (> 70%)
RSQI - Medium signal (> 40%)
RSQI - Bad signal (>= 1%)
RSQI - No signal / No RSQI information (0%)
Antenna - A is currently receiving
Antenna - B is currently receiving
Battery - Shows the remaining battery percentage (> 50% Green, >= 20% Yellow, < 20% Red)
When the RX identification is active (either by triggering from Companion or by pressing the Power Button on a transmitter), a green bar at the bottom of the button is shown. If you are using the preset, the identify action will be already assigned to the button.
In the module presets you will find a status display for every charging bay of your device. It contains the following information:
Beside this information the following icons are used:
Warning - one or more warnings are currently present on the charging bay
Charging Error - The battery can either not get charged or discharged
Communication Error - The charger can't communicate with the battery
Temperature Error - The battery temperature is outside of the supported range (either too cold or too hot)
Overcurrent Error - An overcurrent was detected
Bay State: normal
Bay State: not normal - the current bay state is either UPDATE, ERROR, or DFU_MODE
When the bay identification is active, a green bar at the bottom of the button is shown. If you are using the preset, the identify action will be already assigned to the button.
