Moxa

Moxa ioLogik E1200 Series Control

DIO Control for the Moxa ioLogik E1210, E1211, E1212, E1213 and E1214 using the RESTful API.

Setup

• Enable the RESTful API in the device web console (RESTful API Setting > Enable Restful API). This requires firmware v2.4 or later.
• Select the device firmware in the module config. Firmware v4.0 and later expects a different Accept header to earlier versions.
• On the E1212 and E1213 the DIO channels are set to DI or DO by jumpers. The module uses the channels reported by the device.
• On the E1214 the DO actions, feedbacks and variables control the relays.
• DI/DO mode and pulse widths can't be set through the RESTful API, use the device web console.

Actions

• Get DI Status, Mode & Count
• Reset DI Count
• Set DI Count Start
• Get DO Status, Mode & Pulse
• Set DO Pulse
• Set DO Pulse Count
• Set DO Status

All set actions can be performed against multiple DIs/DOs at once.

Feedbacks

• DI Counter
• DI Mode
• DI Status
• DO Mode
• DO Pulse
• DO Status

Variables

• DI Counter
• DO Pulse Count
• DO Pulse Width High
• DO Pulse Width Low
• Device Name
• Firmware Version
• IP Address
• MAC Address
• Model
• Up Time