Riedel

Riedel Mediornet Module

This module enables the matrix control of Riedels Mediornet.

Configuration

Please enter:

• IP-Address
• Auto-Take
• Reset Selection
• InputCount
• OutputCount

EmBER+ Port is 9000 by specification from Riedel.

IP-Address: Enter the IP Address of the main Mediornet Device

Auto Take: When enabled, a source is routed to the selected destination immediately.

Reset Selection: Reset Source and Target after Take action.

Input-/OutputCount: For offline Programming, you can give a wanted amount of in-/outputs to give you access to all variables and dropdown menues. This value is internally overwritten, when a connection is established.

Available commands

For each matrix there are the two selection actions.

• Select Source
• Select Target

For all matrices exists

• take
• clear
• undo

Available feedbacks

• Source currently selected
• Target currently selected
• Source which is routed to currently selected target
• Source which is routed to specified target
• Valid take feedback, when target and source of the same matrix is selected
• Clear feedback, when something is selected
• Undo, shows when you can undo the last routing process on a selected target

Available presets

• Take
• Clear
• Undo
• Source Selection
• Target Selection

Available variables

Variable name	What it shows
$(INSTANCENAME:input_MATRIXLABEL_SOURCEID)	Label of the specified source in the specified matrix
$(INSTANCENAME:output_MATRIXLABEL_TARGETID)	Label of the specified target in the specified matrix
$(INSTANCENAME:output_MATRIXLABEL_TARGETID_input)	Label of the specified source in the specified matrix routed to the currently selected target
$(INSTANCENAME:output_MATRIXLABEL_TARGETID_input_id)	Id of the specified source in the specified matrix routed to the specified target
$(INSTANCENAME:selected_target)	Label of the selected target
$(INSTANCENAME:selected_target_source)	Label of the source routed to the selected target
$(INSTANCENAME:selected_target_undo_source)	Label of the source which was routed to the target previously
$(INSTANCENAME:selected_source)	Label of the source which is selected