RGBlink

RGBlink Venus X3

Tested with Venus X3 with firmware VER: 4.19

Should also work with X7, however was not tested with X7.

Devices must be controlled over a network, USB control is NOT supported.

Available commands for X3

• Switch selected bank to preview/program with dissolve/cut transition
• Load selected bank (as current bank)
• Switch current bank to preview/program with dissolve/cut transition
• Save banks to selected page
• Load banks from selected page
• Clear selected page
• Power ON/OFF

Available feedbacks (current state) for X3

• Last switch transition (dissolve/cut) and target (preview/program) from selected bank
• Last switch transition (dissolve/cut) and target (preview/program) from any bank
• Selected bank is current
• Selected page is the current page
• Selected page is empty
• Selected page is NOT empty
• All pages are mepty
• Power ON/OFF status

See presets to view examples