Documentation
Nortek Bluebolt
Available commands for Bluebolt (Depends on module connected)
- Power on/off/cycle/toggle bank
- Sequence on/off
- Reboot
- Set Bank Delay
- Reftesh Info
- Refresh Settings
- Enumerate
- Roll Call
- Set Bank Trigger
- Set Brightness
Available variables for Bluebolt (Depends on module connected)
- Current Voltage
- Current Amperage
- Current Wattage
- Current VA
- Current Power Factor
- Bank Power Status
- Remote Sensing
- Surge Protection OK
- Series Mode Protection state
- Smartlink OK
- Power Status
- Squence Status
- Trigger Status
Available feedback for Bluebolt (Depends on module connected)
- Bank Power Status
- Remote Sensing
- Surge Protection OK
- Series Mode Protection power relay state
- Smartlink OK
- Power Status
- Squence Status
Available presets for Bluebolt (UDP models with power variables)
- Toggle Bank 1..N (per-bank, requires polling to be enabled)
- Built-in Bank Power Status feedback styling (green when bank is ON)