Documentation
Gamma Control GMaestro
This module will allow you to remotely operate Gamma Control using the GMaestro protocol.
Configuration
- Enter the IP Address of the device in the configuration settings.
- Choose whether the IP Address is a broadcast address or not. Gamma Control running on every device on the subnet will respond to this broadcast message.
- The device will use UDP port 44188.
- Set Polling Rate for new data
Available Actions:
- Set Values
- Increase/Decrease Master Black Point Luminance By %
- Increase/Decrease Master Middle Gray Balance By %
- Increase/Decrease Master White Point Luminance By %
- Increase/Decrease Red Black By %
- Increase/Decrease Red Middle By %
- Increase/Decrease Red White By %
- Increase/Decrease Green Black By %
- Increase/Decrease Green Middle By %
- Increase/Decrease Green White By %
- Increase/Decrease Blue Black By %
- Increase/Decrease Blue Middle By %
- Increase/Decrease Blue White By %