Loading...
Loading...
N-Series
Controls and monitors DPA Microphones wireless microphone receivers via OSC over TCP.
Enter the receiver's IP address and port (default: 1993) in the module settings. OSC over TCP must be enabled in the receiver's Advanced menu or via DPA Audio Controller software.
| Action | Description |
|---|---|
| Set mute | Mute, unmute or toggle a channel |
| Set channel name | Set the display name for a channel |
| Trigger IR sync | Initiate IR sync on a channel |
| Set radio preset | Set frequency group and channel preset |
| Set RF output power | Set transmitter RF output power |
| Identify device | Flash the receiver display for identification |
Graphical (bar meters)
| Feedback | Description |
|---|---|
| Audio level meter | Vertical bar showing audio level in dBFS. Green→yellow→red. |
| RF antenna strength meter | Vertical bar showing RF signal in dBm. Blue. |
| Battery level meter | Vertical bar showing battery level. Grey. |
Bar position can be set to: left, mid-left, mid-right, right, top or bottom — allowing multiple meters on a single button.
Boolean (button colour)
| Feedback | Description |
|---|---|
| Mute state | Active when channel is muted |
| TX active | Active when transmitter is on and linked |
| Dropout warning | Active on RF dropout (red) |
| Low battery warning | Active at ~15% battery (orange) |
| Critical battery warning | Active below 7.5% battery (dark red) |
| RF interference warning | Active on RF interference (purple) |
| Variable | Description |
|---|---|
$(dpa-wireless:model) | Device model |
$(dpa-wireless:serial) | Serial number |
$(dpa-wireless:device_name) | Device name |
$(dpa-wireless:ch1_name) / ch2_name | Channel name |
$(dpa-wireless:ch1_mute) / ch2_mute | Mute state |
$(dpa-wireless:ch1_tx_active) / ch2_tx_active | TX active state |
$(dpa-wireless:ch1_audio_db) / ch2_audio_db | Audio level in dBFS |
$(dpa-wireless:ch1_battery_pct) / ch2_battery_pct | Battery percentage |
$(dpa-wireless:ch1_battery_min) / ch2_battery_min | Battery remaining (minutes) |
$(dpa-wireless:ch1_rf_a_dbm) / ch1_rf_b_dbm | Ch 1 RF antenna A/B in dBm |
$(dpa-wireless:ch2_rf_a_dbm) / ch2_rf_b_dbm | Ch 2 RF antenna A/B in dBm |
$(dpa-wireless:ch1_tx_name) / ch2_tx_name | Transmitter name |