AVPro Edge

AvProEdge MXnet module

In order to connect the following configuration is required:

• IP Address: The IP address for the IPC control box
• Telnet Port: The telnet port (default is 24)

Supported commands:

• Set Matrix Preset - Activating this command will switch to the specified matrix preset.
• Connect encoder to decoders (matrix aset) - Allows routing an encoder's output to a set of decoders (video and/of audio routing).
• Send IR command - Send an IR command to the specified device (encoder/decoder).
• Send CEC command - Send a CEC command to the specified device (encoder/decoder).

Supported feebacks[1]:

• Decoder has X video source - Is the specified decoder being routed the specified video source?

[1] Note that in order for the feedbacks to work polling needs to be enabled in the connection config.