Arkona Technologies

Arkona Technologies BLADE//runner

Monitor and control Arkona Technologies BLADE//runner frames.

Supported Models

• BLADE//runner AT1130

Getting started

1. Add a connection and choose Arkona Technologies: BLADE//runner.
2. Set Blade IP to the frame's management address.
3. Leave Port at 80 and Protocol at ws (http) unless the Blade is served over HTTPS — then use wss and the HTTPS port.
4. Set a Reservation Marker. The Blade only accepts control commands from a session that holds one. The default is Bitfocus-Connection. If another session (the Blade web UI or another connection) already holds a marker, use that same value to work alongside it, or clear it on the device.
5. Fill in Username and Password only if the Blade is password-protected.

Monitoring variables work without a reservation marker. Routing, BNC direction, identify, reboot, and time-source changes require one. If an action is blocked, match this connection's Reservation Marker to the value shown on the Blade.