Green-GO

Green-GO Intercom OSC Remote

The Green-GO Intercom OSC Remote is a Bitfocus Companion (v3.0) module allowing users to control a wired Green-GO intercom device over the local network.

General Information & Limitations

Because of limitations in the scripting VM present on current Green-GO devices, this Companion module enables you to remotely control a maximum of 6 channels (channels 1 - 6).

It is also worth mentioning that we currently can't support Green-GO WAA antennas or WBPX(SP) belt packs as can't control those devices via OSC.

Please check the tables below for an overview of supported button actions and feedbacks. Also, remember to use the available button presets for easy setup.

If you need more information about the Companion module, please refer to our documentation or contact our community in case you need further assistance.

Prerequisites

• Green-GO device using at least firmware v5.0.3.0255 or above.
• Get the osc-remote.gg5t script and add it to your configuration.
• Use the integrated script editor to adjust the remoteIP (Companion) and controlPort to fit your needs.
• Compile the script to create a binary script for your device(s).
• Load the script on a device, either directly by selecting the device in the index tree or by configuring a user's device profile.
• Save your configuration to your devices to ensure proper operation without the software running in the background.

Configure the Module

There are a few configuration options, of which currently only the first two are required to run this Companion module:

• Device IP: Match this to your Green-GO device's IPv4 address and avoid using broadcast addresses to prevent receiving conflicting states.
• Control Port: Specify the UDP port that is utilized for OSC messages. Please ensure the port number matches the one specified in your osc-remote.gg5t Green-GO script.
• Device Type: This option defines the range of available actions, feedbacks, and presets. In addition, it is used for preset button names.
• Channel Count: Define the number of channels (1 - 6) to control the amount of actions, feedbacks, presets, and variables created for this module. Using a lower number of channels can improve performance and reduce network load.

Available Button Actions

Action	What it does
Set Channel Talk	Control the talk state of a channel
Send Channel Call	Control the call state of a channel
Send Channel Cue	Control the cue state of a channel
Set Channel Listen	Control the listen state (mute channel output) of a channel
Set Channel Level	Control the output level of a channel
Set PGM Level	Control the output level of the program audio special channel
Set Main Level	Control the main output level of the device
Set Input Gain	Control the input gain of the device's active input
Set Input Source	Control the active input source of the user
Set Isolate State	Control the state of the isolate function
Identify Device	Call the device's identfy function to let its status lights blink

<br>

Available Button Feedbacks

Feedback	What it does
Check Channel Talk	React to the current talk state of a channel
Check Channel Call	React to the current call state of a channel
Check Channel Cue	React to the current cue state of a channel
Check Channel Listen	React to the current listen state of a channel (muted/unmuted)
Check Channel Level	React to the current output level of a channel
Check Channel State	React to the current state of a channel (can be used to check for members or active VOX input)
Check PGM Level	React to the current output level of the program audio special channel
Check Main Level	React to the current output level of the device
Check Input Gain	React to the current gain level of the device's active input
Check Isolate State	React to the current isolate state of the device
Online Heartbeat	Check for the the connection state of the device (updated every 5 seconds)